Standards

IEC 62215-3 ed 1.0: Integrated Circuits – Measurement of Impulse Immunity – Part 3: Non-Synchronous Transient Injection Method From the International Electrotechnical Commission webstore: “IEC 62215-3:2013 specifies a method for measuring the immunity of an integrated circuit (IC) to standardized conducted electrical transient disturbances. The disturbances, not necessarily … [Read more...]

From the International Electrotechnical Commission webstore: "IEC 60747-3:2013 gives the requirements for the following devices: signal diodes (excluding diodes designed to operate at frequencies above several hundred MHz); switching diodes (excluding high power rectifier diodes); voltage-regulator diodes; voltage-reference diodes; current-regulator diodes. This edition … [Read more...]

From the International Electrotechnical Commission webstore: "IEC 62496-2-4:2013 specifies the test method to decide whether to pass or fail an optical circuit board using direct illumination by a light. The input ports are directly illuminated and the optical intensity from the output ports of the optical circuit board is monitored using an area image sensor. Excess optical … [Read more...]

From the International Electrotechnical Commission webstore: "IEC 62388:2013(E) specifies the minimum operational and performance requirements, methods of testing and required test results conforming to performance standards not inferior to those adopted by the IMO in Resolution MSC.192(79). "(MSC.192/2) The radar installation, in addition to meeting the general requirements … [Read more...]

From the International Electrotechnical Commission webstore: "IEC/TR 61156-1-5:2013(E), which is a Technical Report, describes correction procedures for the measurement results of return loss and input impedance."   … [Read more...]

From the International Electrotechnical Commission webstore: “IEC 60747-16-5:2013 specifies the terminology, essential ratings and characteristics, and measuring methods of microwave integrated circuit oscillators. This standard is applicable to the fixed and voltage-controlled semiconductor microwave oscillator devices, except the oscillator modules such as synthesizers … [Read more...]

From the International Electrotechnical Commission webstore: "IEC 60255-26:2013 is applicable to measuring relays and protection equipment, taking into account combinations of devices to form schemes for power system protection including the control, monitoring, communication and process interface equipment used with those systems. This standard specifies the requirements for … [Read more...]

From the International Electrotechnical Commission webstore: “IEC 60384-14:2013 [Fixed capacitors for use in electronic equipment - Part 14: Sectional specification - Fixed capacitors for electromagnetic interference suppression and connection to the supply mains] applies to capacitors and resistor-capacitor combinations that will be connected to an a.c. mains or other supply … [Read more...]