Sponsor

Interference Technology

For EMI / EMC Engineers

Sponsor

Standards

Electromagnetic Noise from 10 Hz to 40 GHz Covered in Revised Standard

 

A major revision is now available for IEEE C63.2™, "American National Standard for Electromagnetic Noise and Field Strength Instrumentation, 10 Hz to 40 GHz Specifications." The standard provides electromagnetic compatibility techniques and requirements for instruments measuring quasi-peak, peak, rms, and average values for electrical and electronic equipment for various … [Read more...]

Project CISPR 16-1-4 ed3.0: Pre-Release of Standard

 

Specification for radio disturbance and immunity measuring apparatus and methods – Part 1-4: Radio disturbance and immunity measuring apparatus – Antennas and test sites for radiated disturbance measurements.This part of CISPR 16 specifies the characteristics and performance of equipment for the measurement of radiated disturbances in the frequency range 9 kHz to 18 GHz. … [Read more...]

VCCI International Forum 2010

 

The common theme of this year’s VCCI International Forum is “the latest status of EMC regulation including requirements for radiated disturbance above 1GHz and conducted disturbance at telecommunication ports.” In addition, attendees will learn the latest information including immunity from USA, KC marking from Korea, the latest EMC information from Chinese Taipei, RMC marking … [Read more...]

ETSI Standard Covers EMC Assessment of Base Stations

 

ETSI TS 125 113 V8.5.0: Universal Mobile Telecommunications System (UMTS); Base station and repeater electromagnetic compatibility (EMC) (3GPP TS 25.113 version 8.5.0 Release 8) ETSI TS 125 113 V8.5.0, published this month, covers the assessment of base stations, repeaters and associated ancillary equipment in respect of electromagnetic compatibility. The document specifies the … [Read more...]

ETSI EN 301 839 Part 2

 

Harmonized EN covering essential requirements of article 3.2 of the R&TTE DirectiveETSI EN 301 839-2 V1.3.1, published in October, is part two of a multi-part deliverable covering Short Range Devices (SRD); Ultra Low Power Active Medical Implants (ULP-AMI) and Peripherals (ULP-AMI-P) operating in the frequency range 402 MHz to 405 MHz.LEARN MORE … [Read more...]

ACIL Industry-wide Survey on RF Device Compliance

 

The certification community has a unique perspective on the compliance of new wireless devices. As the number of FCC-certified devices grows to over 10,000 in the past year — and growing year-on-year — the number of intentional radiators marketed each year will approach 20,000 at some time in the near future. To ease access to markets and allow technologies (particularly mature … [Read more...]

IEC 61000-4-7 Ed. 2.1: Updated Standard for Harmonics Measurements

 

Testing and measurement techniques - General guide on harmonics and interharmonics measurements and instrumentation, for power supply systems and equipment connected thereto.IEC 61000-4-7:2002+A1:2008 applies to instrumentation intended for measuring spectral components in the frequency range up to 9 kHz which are superimposed on the fundamental of the power supply systems at … [Read more...]

ETSI EN 301 839 Part 1

 

Technical characteristics and test methodsETSI EN 301 839-1 V1.3.1, published in October, is part 1 of a multi-part deliverable covering Short Range Devices; Ultra Low Power Active Medical Implants (ULP-AMI) and Peripherals (ULP-AMI-P) operating in the frequency range 402 MHz to 405 MHzElectromagnetic compatibility and Radio spectrum Matters; Short Range Devices; Ultra Low … [Read more...]

Industry Sponsors

Sponsor
Sponsor