Sponsor

Interference Technology

For EMI / EMC Engineers

Sponsor

Former EMC Society President Bob Hofmann on the Mend

 

Long time IEEE EMC Society member and past president Bob Hofmann is currently recuperating from a fall that occurred as he arrived home from a VCCI-related trip to Japan. Apparently, he sustained a fall and some head injuries as he was dropped off at his home. This past weekend, he underwent surgery to correct bleeding and remains hospitalized. The very good news is that the … [Read more...]

High Speed Suppression Chip and Array Family Employs Unique Air Gap Technology to Achieve Low Capacitance

 

RALEIGH, NC (July 7, 2009) – Stackpole Electronics, Inc. has announced the release of two new circuit protection devices designed for compliance with IEC 61000-4-2. The ESD/ESDU Series are high-speed ultra high-speed transient suppression chips with an 8-kV protection level for direct contact and 15-kV for air. The ESA/ESAU Series are chip array versions of these suppression … [Read more...]

Portable EMC Surge Tester Adheres to the Latest Standards

 

The new CDN 3038-S100M from Teseq, Inc. is a portable coupling/decoupling network that allows for easy mobility between test sites. Crafted to test to the latest IEC 61000-4-5 and ANSI C62.4 specifications, this device will provide high current and voltage surge testing in a number of applications including power converters, fuel cells, and fixed installations. The device … [Read more...]

ESD Protection Diode for RF Antennas

 

The ESD0P2RF-02LS from Infineon Technologies is 0.62 mm x 0.32 mm with a height of 0.31 mm. It can be easily integrated into complete modules and front-end systems. Crafted to protect electronic consumer and communications devices from electrostatic discharge, it can reliably absorb discharges up to 20 kV, a figure that significantly exceeds the industry standard IEC 61000-4-4 … [Read more...]

Standard on Limitation of Voltage Fluctuations and Flicker in Low-Voltage Power Supplies

 

"IEC/TS 61000-3-5:2009 deals with emission of disturbances due to voltage fluctuations and flicker. The recommendations in this technical specification are applicable to electrical and electronic equipment that has a rated input current exceeding 75 A per phase and is intended to be connected to a public low-voltage a.c. distribution system. Recommendations that specify … [Read more...]

Surface Mount GDT Surge Protectors for Broadband Applications

 

The new Bourns® 2054 series targets broadband applications. These three-electrode, surface mount GDT (gas discharge tube) surge protectors feature low capacitance and low insertion and return loss, making them a suitable choice for such applications. These devices are available in voltages from 230 V to 470 V. They prevent surge damage by providing a short-to-ground circuit … [Read more...]

ESD Protection Diode for RF Antennas

 

The DSD0P2RF-02LS from Infineon Technologies is 0.62 mm x 0.32 mm with a height of 0.31 mm. It can be easily integrated into complete modules and front-end systems. Crafted to protect electronic consumer and communications device from electrostatic discharge, it can reliably absorb discharges up to 20 kV, a figure that significantly exceeds the industry stand IEC 61000-4-4 … [Read more...]

Industry Sponsors

Sponsor
Sponsor